TurboCAD Mac Forum

TurboCAD Mac Categories => General Discussion => Topic started by: Maplehead on January 02, 2019, 08:25:04 AM

Title: Rounding edges
Post by: Maplehead on January 02, 2019, 08:25:04 AM
Hi All
Should I be able to round the edges of this D logo and the top edges of the cover itself?
I want to but I am getting every error in the book when I try the various chamfering features.
Ideally I would have the edges rounded and then the D logo would be hollow from the inside, like the cover, so that I could have a punch and die made to punch these out.
Title: Re: Rounding edges
Post by: JBorlaug on January 02, 2019, 01:09:31 PM
Try the Blend edge tool instead of the chamfer/radius there Maplehead!
Title: Re: Rounding edges
Post by: mitchb on January 02, 2019, 05:29:51 PM
It would be better to post your drawing rather than an image. I would like to see if this is one piece or several parts.

Enjoy
Mitch