TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

snaps
Read 13 times
* September 22, 2017, 11:08:54 AM
When using any drawing tool or the select tool with Turbocad 8 it will only snap to the desired point if I insert it above the target.  This problem only appears in the vertical plane.  For example, if I try to insert a vertical dimension it comes out above the target position, but the problem does not occur with horizontal dimensions.  This has suddenly come up today after years of trouble free drawing.  Can anybody help me (in simple language please!)

Logged


* September 22, 2017, 01:29:09 PM
#1
Hi RSS,
That sure sounds strange, could you post a screenshot and sample drawing where this happens? I need a better understanding of the problem.

Enjoy
Mitch

Logged