TurboCAD Mac Forum

New TurboCAD Mac 2D/3D Training Essentials

How to 'Fill'
Read 16827 times
* August 03, 2017, 06:35:50 AM
Thanks Mitch.

Quite a lot to absorb there. I think perhaps I need to spend some time on the 'Verify' section of the TurboCAD manual!

Just one question for now. How do I get to the 'Repair Curves' tool (remembering I'm using ctrl click in the absence of a right click).

Kind regards



* August 03, 2017, 07:37:37 PM
Hi Andrew,

The "Repair Curves" tool is new in V10, it's at the end of the Trim tool bar.

I'm very leery of letting the tool do the repair, you will be much better off zooming in and making the repair yourself. The program will change your geometry in ways you may not want. After repairing, rerun the tool, it may find more errors.