TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

Applying Hatch Mac pro V8
Read 690 times
* July 21, 2015, 02:21:45 PM
Hi I am trying to apply cross hatching to an object eg a circle I have selected the part nominated angle and spacing for the hatch click ok the screen shows the "SONAR" swirl that it is complete yet no hatch appears. When the shape is selected it even says hatch XXX. So Hatch is invisible!? In the help menu instruction are simple. I Know I am doing something wrong but I don't know what?

Any help would be appreciated.

Logged


* July 22, 2015, 12:57:06 AM
#1
If the circle is small and the hatch large then you may be looking at an empty part of the hatch. If the circle is filled then select the hatch and under the "Edit" menu select "Arrange" then "Bring To Front". If that doesn't get you going then post the drawing for us to look at.

by the way, this thread should be in the "Problems" section. Open it in there to continue the discussion.

Enjoy
Mitch
« Last Edit: July 22, 2015, 01:03:05 AM by mitchb »

Logged


* July 23, 2015, 02:12:45 PM
#2
Ok thanks Mitch,

Much appreciated.
Will do both.

Regards
Iain


Logged