TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

Rationalising menus
Read 90 times
* April 26, 2017, 03:32:17 AM
So on v10
top menu>advance transform>  none of the 5 options in the sub menu actually relate to function.
OK? ish
Then I try to circumnavigate this by trying to assign a short cut I am again defeated.
The listing of functions in the short cut menu is totally random. It is not alphabetical,  it doesn't follow the options as set out in the ribbons, or, wait a  minute, it might have started life following this but then veers off on its own path. I still can't find  align.
Would you explain?

Logged


* April 26, 2017, 01:25:07 PM
#1
You are looking for XForm utils. You will find "Align" there. Using the letter X in place of "trans" is an idiosyncrasy of the English language.

Enjoy
Mitch

Logged