TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

is there a way to set default snap preferences?
Read 56 times
* January 03, 2018, 06:09:04 PM
Please help me figure out if there's a way to set default preferences for snaps.  I'm running TurboCad MAC Pro v10.  It seems that the snap selection menu picks stay consistent within a TurboCad session, but once you restart TurboCAD or the computer, it defaults to the default snap settings (a small image of the default settings is attached for reference).  I was unable to find a way to do this via the User's Manual, the Preferences menu (TurboCad Mac Pro 10 -> Preferences), or this Forum, and a Google search did not turn up anything.  A way to work around this problem would be to create a template file / starter file with the snaps pre-selected.  Does anyone have a better idea?

Thanks,
Sam

Logged


* January 03, 2018, 07:03:17 PM
#1
The start condition of these buttons (on/off) is set by the programmer while developing the snaps palette so they will always launch in their selected condition. You can set up shortcut keys to turn them on or off but in most cases, just clicking on them is easier.

Enjoy
Mitch

Logged


* January 04, 2018, 08:47:21 AM
#2
Thanks Mitch.

Sam

Logged