TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

SPUR Gear Creation
Read 330 times
* October 19, 2018, 03:57:33 AM
Available in Products: Available in optional PowerPack module.         

This feature is available in Optional Powerpack Module. The spur gear teeth in TurboCAD use an involute curve. The involute curve is the curve traced by a point on a straight line with rolls without slipping.

Spur Gears in TurboCAD are defined with the following parameters.
   Number of Teeth
   Module
   Pressure Angle
   Cone Angle
   Clearance
   Involute Samples
   Inner Hole Diameter
   Thickness

Logged
Thanks & Regards,
Zunair Attif
QA\Support Manager


October 24, 2018, 08:56:37 PM
#1
WOW Tim sure has been busy! :D

Logged