TurboCAD Mac Forum

Register
 
New TurboCAD Mac 2D/3D Training Essentials

Faceted Sculpture creation easy in reality but in CAD ???
Read 526 times
* October 20, 2019, 01:46:56 AM
My very slow learning curve on TC progresses,  I only use CAD occasionally but thanks to this forum I learn a bit slowly, it is very helpful.

The sculpture for Port Glasgow I have been working on for several years now is progressing well. Two colossal shipbuilding figures fabricated in stainless steel sheet, standing 11 metres high each. So hopefully attached here is a head of the 'Grumpy' shipbuilder. I was wondering if there would be a way of drawing this in TurboCad, maybe assembling pieces of sheet as the facets and building it on screen. I would need to have each facet in a format that could be stretched at each corner, rotated in space, attached to adjacent facets, but always able to be adjusted. Do you think it is possible?


Logged


* October 20, 2019, 01:52:44 AM
#1
Happy Head on other figure. The plug (spot welds) symbolize rivets of ship hulls - they do not need to be drawn in the TurboCAD version.

Logged